Water Damaged Drywall in Meridian, Idaho

Meridian Quality Drywall replaces water damaged drywall in Meridian after ice-maker lines, second-floor overflows, and roof drips have already been stopped. Soft gypsum is not a paint problem. It is a cut-out. The new hang waits until the cavity is dry.

Call (208) 382-8431 with photos of the stain, whether the leak is dead, and the room. We quote the cut-out and the new hang, not the plumbing.

Water Damaged Drywall Options for Meridian Properties

Ceiling cut-out under a bath

A second-floor shower or tub that overflowed. We open the lid to solid board, check the insulation, and leave the cavity open until it is dry. New 5/8-inch on 24-inch joists if that was the spec. Texture to the field.

Kitchen ice-maker and fridge lines

A slow drip behind a fridge soaks a small field of a wall or a lid. The stain looks small. The paper is often wet farther than the brown ring. We cut to dry core, not to the stain line.

Bath and laundry replacement with MR board

Wet-room walls that stayed wet get moisture-resistant board back, not regular white. Shower surrounds that failed get cement board, not green board. The replacement follows the wet zone, not the old sheet's brand.

Hard stain, leak already dead

If the gypsum is hard and the meter is dry, we can stain-block and retexture. This is the exception. We still probe. A hard ring next to a soft bay is two different scopes.

How We Handle Water Damaged Drywall in Meridian

1. Confirm the leak is dead. If water is still moving, we stop and the right trade goes first.
2. Probe. Press the field. Meter if we need to. Mark the cut on solid board.
3. Cut to studs when we can. Bag the wet gypsum. Leave the cavity open to dry.
4. Hang new board that matches the room: Type X, MR, or regular. Tape in setting compound.
5. Texture to the field and prime. Paint is a separate step unless you ask us to stop at primer.

Materials and Methods

ASTM C1396 replacement sheets. Moisture-resistant board in baths and laundry. Cement board in showers. Type X where the assembly was rated. Paper tape. Setting-type mud on that tape coat because the patch is small and Meridian air shrinks ready-mix. Stain-blocking primer on hard stains that stay. A moisture meter. Bags for wet debris. We do not hang over wet insulation. We do not use regular paper-faced board in a shower. GA-216 hanging practice still applies on the new piece. Flood cuts on walls land above the waterline on a stud, not mid-bay.

Wet board comes out to a dry edge. New ASTM C1396, hung to ASTM C840, taped with ASTM C475 paper tape. Type X if the plane was rated. Cement board if the surround was wet. Setting-type compound on the tape coat. Moisture meter on the remaining studs. GA-216 fastener pattern. We hang after the leak is dead. A stain-blocking primer on any remaining mark.

Ice-maker lines behind south Meridian fridges are a common small cut-out. The stain on the lid in the kitchen looks like a foot. The wet paper in the bay is often three feet. We cut to dry core. We do not paint the ring and leave the wet bay.

Second-floor baths over living rooms are the larger job. Insulation in the floor comes out if it is wet. We are not the restoration dryer. We hang when the wood and the bay are ready. Hanging on wet joists traps the problem.

What Water Damaged Drywall Costs in Meridian

Fixr puts water-damage drywall repair on a single room around 400 to 800 dollars nationally, and lists flood-cut work in the same band. HomeAdvisor's repair guide puts water damage around 600 to 1,550 dollars and ceiling work around 220 to 1,300. Thumbtack groups many ceiling repairs from 354 to 1,064 dollars. Height, how far the wet field runs, and MR versus Type X board move a Meridian quote. Drying time is not a gypsum quote. We quote the cut-out and the hang after the cavity is ready.

Laundry overflows and ice-makers are the small wet jobs. Roof drips at a vault are the large ones. A vault stain that is still soft means the roof trade is not done. We will not close a vault over an active drip. The new board would stain on week two.

Mold on paper face is a cut-out of that field, not a bleach wipe we sell as a finish. We remove the wet gypsum. Underlying moisture is another trade. We hang clean board on dry framing. That is the scope we quote.

Water Damaged Drywall Questions

When does stained board have to come out?

If the core is soft, crumbling, or still wet, it comes out. Hard board with a dead stain can take a stain-blocker and a retexture. We press the field. Soft is a cut-out.

Do you fix the leak?

No. A plumber, a roofer, or whoever owns the water stops it first. We hang after the cavity is dry. Coating over an active leak is a redo.

What board goes back in a bath or laundry?

Moisture-resistant green or purple gypsum outside the shower. Cement board in the shower. Regular white board does not go back on a wet-room wall.

How much past the stain do you cut?

To solid, dry board, often a foot past the last soft edge, and to the next studs when we can. Flood cuts on walls usually land a couple of feet above the waterline.

Call (208) 382-8431 with photos and whether the leak is already stopped.